Urinal Manual Flush Valve

Hand twist latrines product caged to do for this kind of twist type product, if caged water, that's because the inside of the valve core due to long-term use, lead to wear and untight seal valve core, can change a valve core can be solved. In the replacement Before new valve core, you have to buy and use their model is consistent with the product valve core, and then use a cross screwdriver ready. Before disassembling must turn off the main switch of the water, then twist type valve handle product in the hand, with a small blade it Valve handle the small risk on gently pry the, you can see the inside of the screw. With push button toilet flush valve a phillips screwdriver to screw screwed down and removing the handle, after removing the can see the inside of the valve core, and then using a wrench clockwise will reveal a valve core. The new valve core Installation, will the previous steps, in turn, the operation, the other components to install back then. Under open the tap water valve, check whether there is leakage, if there is no problem with the handle, and tighten the cap on the turnbuckle.
Because of the different place, toilet use wash valve is not the same, at present the flush valve has three types: induction, beeline and manual type. The principle of induction flush valve is: flush valve feel the body heat, heat to wash after disappear.
Automatic flushing device equipped with infrared receiving probe. When close to human body, the probe can be sent with enough strength to receive the body of infrared light. Electric control circuit action, make the flush valve and keep two seconds, drainage at a time. The body away, probe to receive Infrared reduction, reduction and control circuit, electromagnetic valve open 3 seconds, then Urinal Manual Flush Valve drain again. Under normal condition, pedal product, aprons and water body cavity of the combination of water pressure and the gravity of the valve core, make the aprons and outlet seal Blocking waterways. On waste pedal after pressure relief valve core rod axis deviation from 3 to 5 degrees, rinse mouth connected to the water cavity. At this point, the body cavity of the upper water static pressure release, cavity pressure is equal to atmospheric pressure, tube hydraulic upward push valve core, water and a tube Nozzle connection, form a larger flow, thus finish washing work.
Soaking with the toilet net (oxalic acid), remove the scale, there are the part of the telescopic activities add some oil. Put back to use. Flush valve leakage suggested replacement. The working principle of the product: when Water from the inlet into the water tank, the drain by rubber membrane Manual Flush Valve pressure, can't drain. As the water level rises, the water through a hole through the ball in the champions league, and flows from the hole b into the bend.
Due to the rubber membrane and water pressure are equal, still pressure drain. Repair the toilet product Method is as follows: first shut into water total brake; Although memory opened the lowest faucet, in boiling water; With a hammer shook loose copper ball valve of the articulated below; With the appropriate pipe wrench Service Sink Faucets will live after nut loose, the water pipe is split in two, the valve can be removed; In into Entangled with sponge or cloth pipe, to ensure the normal water, the last of the 1.5 l juice bottles filled with water in the tank, it can also save water, can also reduce water time. When installation, can't get in and out of the water in water, should be water pipe above again The nut on the installation of synthetic again, pay attention to the tilt of the aprons mouth will face up. Installation after water connection, try each connection parts for leaks, can use when confirmed.